ZAR®
ULTRA
Awarded the Popular Mechanics — Editor's Choice Award for outstanding
achievement in new product design and innovations!
ZAR®
ULTRA Polyurethane is a super fast-drying oil-based clear wood Polyurethane
finish. Dries on two hours on bare wood. ZAR® ULTRA brushes on easily
to create a tough abrasion-resistant finish for hardwood floors, cabinets,
furniture, bartops, countertops, wall paneling and woodworking.
-
Great
for floors, dries in 2 hours
-
Tough abrasion-resistant finish
-
Smooth,
self-leveling formula
-
For
floors, doors and furniture
DESCRIPTION
ZAR ULTRA Polyurethane is a super fast drying clear wood polyurethane
finish. For interior use only. Dries in two hours on bare wood. ZAR ULTRA
Polyurethane brushes on easily to create a tough abrasion resistant finish
for hardwood floors, cabinets, furniture, bartops, countertops, wall paneling
and woodwork. Self-leveling for a smooth finish without brush marks. Resists
scuff marks, alcohol and household chemicals. A damp cloth renews the
finish. Never needs wax. Child safe when dry.
SURFACE
PREP
New Wood: Sand smooth using fine sandpaper. Remove sanding dust
with tack rag or cloth dampened with paint thinner or mineral spirits.
Old Clear Finishes in Good Condition: Remove grease,
dirt and wax. Sand lightly in the direction of the grain to remove any
gloss. Clean dust with cloth dampened with paint thinner or mineral spirits.
Old Clear Finishes in Poor Condition, Lacquer or Shellac:
Remove completely. If the old finish contains wax or stearates, regardless
of condition, remove completely. Sand and remove sanding dust with cloth
dampened with paint thinner or mineral spirits.
Interior surfaces of Stained Steel or Fiberglass Entry Doors:
Do not sand stained door surfaces. Wood Stain must be thoroughly dry.
APPLICATION
Stir
all sheens except ZAR ULTRA Gloss Polyurethane thoroughly before and during
application. Stirring is not required for ZAR ULTRA Gloss Polyurethane
finish. Do not shake! Apply straight from the can. DO NOT THIN. Use a
clean bristle brush or lambs wool applicator. Dip the brush in the can
and let excess drip off. Flow ZAR ULTRA on in the direction of the grain.
Avoid over- brushing which may trap air bubbles in the finish and result
in streaks. Make final pass of applicator a skimming stroke across the
entire surface.
DRYING
Allow to dry 2 hours between coats. Allow final coat to dry 4-6 hours.
Temperature, humidity and film thickness may affect drying time. If while
sanding, sandpaper gums or surface feels tacky, extend drying times.
CLEAN-UP
Clean brushes and tools immediately after use with paint thinner or mineral
spirits.
COVERAGE
500-600 sq. ft. per gallon
|
