Minwax® Water Based Wood Stain is a fast and easy way to add beautiful color to unfinished wood. It comes in 50 traditional wood tones and contemporary decorative colors. Minwax® Water Based Wood Stain is fast-drying, low odor, and can be easily cleaned up with soap and water. When used with Minwax® Water Based Pre-Stain Conditioner, it provides rich, beautiful color results.

NOTE:Minwax® Water Based Wood Stain is not recommended for large surfaces, such as floors.

DIRECTIONS:

SURFACE PREPARATION:
•Sand the wood in the direction of the grain, first using medium-grade sandpaper (#120) working your way to fine-grade sandpaper (#220). Do Not Use Steel Wool. Remove all sanding dust.
•Apply Minwax® Water Based Pre-Stain Wood Conditioner and allow to penetrate 1-5 minutes. This will help ensure even stain color penetration and reduce grain raising on soft and hard woods. Remove excess with a clean cloth.
•For best results, wait 15-30 minutes before lightly sanding the surface with a fine-grade sandpaper. This will help smooth any raised grain. Remove all sanding dust.

STAIN APPLICATION:
•Stir contents thoroughly before and during use.
•Test stain on a hidden area to verify desired color.
•When working with more than one can, we recommend mixing together the contents of the cans to ensure color consistency.
• Apply stain with a synthetic bristle brush, foam brush, staining pad or rag. Allow stain to penetrate no longer than 3 minutes.
•While stain is still wet, remove excess with clean cloth lightly dampened with stain. Wipe in the direction of the grain using light to medium pressure to achieve even stain color.
•Note: Any uneven color penetration can be blended. Rewet the surface with more stain and lightly rub the stain into the surface, blending light and dark areas.
•To increase color intensity, apply a second coat after 2 hours- repeating directions for application of first coat. Heavier application, lower temperature, and or higher humidity will extend drying time. Do not apply below 55°F.

CLEAR FINISH APPLICATION:
•Allow stain to dry a minimum of 3 hours before applying a clear protective finish. For a durable, crystal clear, ultra-fast drying finish we recommend Minwax® Polycrylic® Protective Finish. Minwax® Fast-Drying Polyurethane or Minwax® Wipe-On Poly can also be used over Water Based Wood Stain.
Note: Minwax® Water Based Wood Stain is not recommended for use on floors.

COVERAGE: Approximately 100 sq. ft. per quart.

CLEANUP: Soap and warm water.