ZAR®
QUICK DRY SANDING SEALER POLYURETHANE
A fast drying sealer. Dries in one hour on bare wood. For floors, furniture,
cabinets and woodwork. Ideal as a finish coat or as an undercoating
with ZAR® Interior Polyurethane. Can also be used as a primer to
seal bare, open-grained wood before staining.
DESCRIPTION
ZAR Quick Dry Polyurethane Sanding Sealer is for interior use only.
A fast drying sanding sealer for floors, furniture, paneling, cabinets,
counter tops and woodwork. Dries in one hour on bare wood. Use as a
first and/or second coat under Interior ZAR Gloss, Semi-Gloss, Satin
or Antique
Flat Polyurethane and under ZAR ULTRA Gloss, Semi-Gloss or Satin.
SURFACE
PREP
New Wood: Sand smooth using fine sandpaper and wipe claen all
sanding dust with tack rag or cloth dampened with mineral spirits.
Old Clear Finishes in Good Condition: Remove grease,
dirt and wax. Sand lightly in the direction of the grain to remove any
gloss. Clean sanding dust with tack rag or cloth dampened with mineral
spirits.
Old Clear Finishes in Poor Condition, Lacquer or Shellac:
Remove completely. If the old finish contains wax or stearates, regardless
of condition, remove completely. Sand and remove all sanding dust.
Do not apply over wood fillers or finishes containing stearates.
APPLICATION
Stir
thoroughly before and during application. Do not shake! Apply straight
from the can. DO NOT THIN. May be applied by brush, pads, lambs wool applicator
or spray. Flow ZAR on in the direction of the grain. Sand lightly between
coats. Dust and wipe clean. If more than 24 hours elapse between coats,
sand thoroughly and clean.
DRYING
Allow first coat to dry 1 hour. Succeeding coats up to 2 hours. Temperature,
humidity and film thickness may affect drying time. If while sanding,
sandpaper gums or surface feels tacky, extend drying times.
CLEAN-UP
Clean brushes and tools immediately after use with paint thinner or mineral
spirits.
COVERAGE
Up
to 500-600 sq. ft. per gallon.
|
