DRYLOK®
LATEX BONDING AGENT
DRYLOK® Latex Bonding Agent bonds concrete and plaster to difficult
surfaces such as dense, slick or porous concrete, stone, drywall, hardboard
and plaster walls. When used as an additive to concrete mixes for patching,
DRYLOK® Bonding Agent improves the adhesion and increases the resiliency
and elasticity of the patch. DRYLOK® Bonding Agent may also be used
for pointing of plaster cracks.
DESCRIPTION
DRYLOK Latex Bonding Agent bonds concrete and plaster to difficult surfaces
such as dense or slick concrete, stone, drywall, hardboard and plaster
walls. When used as an additive to concrete mixes for patching, DRYLOK
Latex Bonding Agent improves the adhesion and increases the resiliency
and elasticity of the patch which greatly extends the life of the repaired
area. DRYLOK Latex Bonding Agent may also be used to prime plaster cracks
by brushing into the crack before filling with plaster. This assures
a long lasting, tight bond of the patch to the original surface.
SURFACE
PREP
Surface must be clean, dry and free of oil, grease and powdery
or peeling materials. Protect from freezing. If DRYLOK Latex Bonding
Agent arrives in a frozen condition, allow to thaw at room temperature
for 24 hours before using.
APPLICATION
Apply by brush or spray. Once DRYLOK Latex Bonding
Agent changes from milky color to a clear glaze (approx. 30 minutes)
it is dry and ready for a top coating of plaster or concrete.
MIXING
WITH CEMENT POWDER
DRYLOK Latex Bonding Agent can be mixed with concrete patching
material in place of water to improve bonding of patch to masonry surfaces.
Slowly add DRYLOK Latex Bonding Agent to cement powder (1 quart DRYLOK
Latex Bonding Agent to 3 parts cement powder for normal repairs) stirring
constantly until consistency is smooth. Adjust consistency if necessary
by adding additional latex or cement. When repairing small cracks, mix
DRYLOK Latex Bonding Agent and concrete powder to a thin consistency;
for deep or wide repairs, use a heavy consistency.
COVERAGE
Depending on the porosity and texture of the surface, DRYLOK
Latex Bonding Agent will cover up to 500 square feet per gallon.
CLEAN-UP
Application
tools should be washed with soap and water immediately after using.
|
